Subheading
7306.30
Other tubes, pipes and hollow profiles (for example, open seamed or welded, riveted or similarly closed), of iron or steel: Other, welded, of circular cross section, of iron or nonalloy steel:
7306 Other tubes, pipes and hollow profiles (for example, open seamed or welded, riveted or similarly closed), of iron or steel
Duty rates
Column 1, General
Not stated at any level above this lineThe rate for goods from countries with normal trade relations.
Column 1, Special
No programme rate on this lineOnly if the goods qualify under that programme's rules of origin, which is a determination nobody here can make for you.
Column 2
Not stated at any level above this lineFor the small number of countries named in General Note 3(b), which is not held here.
Additional duties
No footnote on this line, or on the lines above it, points at a chapter 99 provision.
These are the published rates for this line. They are not a landed duty. Additional duties under chapter 99, which is where section 232 and section 301 sit, can apply through the U.S. notes to that chapter without a footnote on this line, and those notes are not held here. Classification and country of origin are yours to determine.
Below this
| Code | Description | General |
|---|---|---|
| 7306.30.10 | Having a wall thickness of less than 1.65 mm | Free |
| 7306.30.10.10 | Internally coated or lined with a non-electrically insulating material, suitable for use as electrical conduit | Free |
| 7306.30.10.90 | Other | Free |
| 7306.30.30.00 | Tapered steel pipes and tubes principally used as parts of illuminating articles | Free |
| 7306.30.50 | Other | Free |
| 7306.30.50.10 | Suitable for use in boilers, superheaters, heat exchangers, condensers, refining furnaces and feedwater heaters, whether or not cold drawn | Free |
| 7306.30.50.15 | Other, cold-drawn | Free |
| 7306.30.50.20 | Other, cold-rolled (cold-reduced) with a wall thickness not exceeding 2.54 mm | Free |
| 7306.30.50.26 | With an outside diameter not exceeding 50.8 mm | Free |
| 7306.30.50.27 | With an outside diameter exceeding 50.8 mm but not exceeding 114.3 mm | Free |
| 7306.30.50.28 | Internally coated or lined with a non-electrically insulating material, suitable for use as electrical conduit | Free |
| 7306.30.50.31 | With an outside diameter not exceeding 50.8 mm | Free |
| 7306.30.50.33 | With an outside diameter exceeding 50.8 mm but not exceeding 114.3 mm | Free |
| 7306.30.50.35 | Tube and pipe hollows for redrawing | Free |
| 7306.30.50.41 | With an outside diameter not exceeding 50.8 mm | Free |
| 7306.30.50.43 | With an outside diameter exceeding 50.8 mm but not exceeding 114.3 mm | Free |
| 7306.30.50.56 | With an outside diameter not exceeding 50.8 mm | Free |
| 7306.30.50.57 | With an outside diameter exceeding 50.8 mm but not exceeding 114.3 mm | Free |
| 7306.30.50.85 | Galvanized | Free |
| 7306.30.50.90 | Other | Free |
Keep this line
An account can watch this line, so a section 232 or 301 action naming it reopens the determination that rested on it.
2026HTSRev17, retrieved 2026-08-27, from the USITC