Subheading
7415.33.80
Nails, tacks, drawing pins, staples (other than those of heading 8305) and similar articles, of copper or of iron or steel with heads of copper; screws, bolts, nuts, screw hooks, rivets, cotters, cotter pins, washers (including spring washers) and similar articles, of copper: Other threaded articles: Screws, bolts and nuts: Other screws and bolts; nuts
7415 Nails, tacks, drawing pins, staples (other than those of heading 8305) and similar articles, of copper or of iron or steel with heads of copper; screws, bolts, nuts, screw hooks, rivets, cotters, cotter pins, washers (including spring washers) and similar articles, of copper › 7415.33 Screws, bolts and nuts
Duty rates
Column 1, General
3%The rate for goods from countries with normal trade relations.
Column 1, Special
Free (A,AU,B,BH,CL,CO,D,E,IL,JO,KR,MA,OM,P,PA,PE,S,SG)Only if the goods qualify under that programme's rules of origin, which is a determination nobody here can make for you.
Column 2
45%For the small number of countries named in General Note 3(b), which is not held here.
Programmes named in the Special column:
- A, Generalized System of Preferences
- AU, Australia Free Trade Agreement
- B, Automotive Products Trade Act
- BH, Bahrain Free Trade Agreement
- CL, Chile Free Trade Agreement
- CO, Colombia Trade Promotion Agreement
- D, African Growth and Opportunity Act
- E, Caribbean Basin Economic Recovery Act
- IL, Israel Free Trade Area
- JO, Jordan Free Trade Agreement
- KR, Korea Free Trade Agreement
- MA, Morocco Free Trade Agreement
- OM, Oman Free Trade Agreement
- P, Dominican Republic and Central America Free Trade Agreement
- PA, Panama Trade Promotion Agreement
- PE, Peru Trade Promotion Agreement
- S, United States, Mexico and Canada Agreement
- SG, Singapore Free Trade Agreement
Additional duties
No footnote on this line, or on the lines above it, points at a chapter 99 provision.
These are the published rates for this line. They are not a landed duty. Additional duties under chapter 99, which is where section 232 and section 301 sit, can apply through the U.S. notes to that chapter without a footnote on this line, and those notes are not held here. Classification and country of origin are yours to determine.
Below this
| Code | Description | General |
|---|---|---|
| 7415.33.80.10 | Having shanks, threads or holes 6 mm or more in diameter | 3% |
| 7415.33.80.50 | Having shanks, threads or holes less than 6 mm in diameter | 3% |
Keep this line
An account can watch this line, so a section 232 or 301 action naming it reopens the determination that rested on it.
2026HTSRev17, retrieved 2026-08-27, from the USITC